Cannon C110DPX manual Care and Cleaning

Care and Cleaning

Grill	Remove the grill pan and the wire grid food support, it is best to wash these items immediately after
	use to prevent stains from being burnt on when used again. Wipe out the Grill compartment, use a fine
	steel wool soap pad to remove stubborn stains from the grill runners and the floor of the compartment.
	Wipe over the control panel with a damp cloth and polish with a dry cloth.
Control Panel	Do not use cream cleaners, oven cleaners or aerosols, scouring pads or abrasive powder for
	cleaning the plastic knobs as damage will occur.
Decorative Trims	It is advisable to clean the decorative trims regularly to prevent any build up of soiling.The
	recommended method of cleaning is to wipe over the trims with a soft cloth wrung out in warm water or
	mild non-abrasive cleaner. (If in doubt try the cleaner on a small area of trim which is not noticeable in
	normal use). Then, after wiping with a cloth wrung out in clear water, dry with a soft clean cloth.
Doors	Wipe over the outer door glass panels with a cloth wrung out in warm soapy water, then after wiping
	with a cloth wrung out in clear water, dry with a soft clean cloth. Ensure that glass doors are not
	subjected to any sharp mechanical blows.
	Glass Inner Door Panel (where fitted) – open the door fully and unscrew the two screws securing
	the glass panel, taking care not to allow the glass to fall. The glass panel may now be washed at the
	sink. Stubborn stains can be removed by using a fine steel wool soap pad. Ensure the glass panel is
	not subjected to any sharp mechanical blows. Take particular care not to damage the inner
	surface which is coated with a heat reflective layer. After cleaning, rinse and dry with a soft cloth. For
	slight soiling the inner glass panel may be cleaned, while still warm, without removing it from the door.
	Warning: Oven must not be operated with inner door glass removed.
	Take care during cleaning not to damage or distort the door seals. Do not lift the door seal from the
	oven chassis, if necessary remove the seal by carefully unhooking the corner clips.
	Take care that the rating label edges are not lifted during cleaning, and furthermore that the lettering is
	not blurred or removed.
Ovens	Remove the rod shelves and grill pan. Use a fine steel wool soap pad to remove stubborn stains from
	the rod shelves, grill pan and the floor of the oven. Clean the glass part of the oven door using a
	sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough
	abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to
	crack.

Oven Shelf Supports

Oven Lamp Replacement

The shelf supports are removable and dishwasher safe.

To remove hold the support at the front and pull away from the oven side, this can then be cleaned in a sink or a dishwasher.When removed it allows access to the oven side, which can be cleaned with warm soapy water.

To refit the support, insert the longer leg into the rear fixing hole and push in the front leg.

Open the oven door and remove the rod shelves. Using a suitable cloth to protect the fingers grip the light glass dome, unscrew anti-clockwise and lift. Reach into the aperture with fingers, and unscrew the lamp anticlockwise. Fit replacement lamp (25W 300°C rated SES), refit dome.

WARNING:To avoid electric shocks - please ensure that the electricity supply to the appliance

is switched off and the appliance is fully cold, before removing the lamp lens.

24