Caring for your Cooker Hood

Before doing any cleaning or replacing the fil- ters or light bulb, always ensure that the elec- tricity supply to the Cooker Hood is switched ‘OFF’.

Filters and their replacement:

THE GREASE FILTER -

Your Cooker Hood is fitted with a grease filter which absorbs grease, dust etc. and helps to keep the appliance clean inside. Gradually the filter will become saturated with grease and when this happens the visual indicator stripes will start to be seen through the filter grille. When the stripes are clearly visible from out- side the Hood - the grease filter must be replaced.

IMPORTANT: There could be a possible fire hazard if the grease filter is not replaced when necessary and according to these instructions.

Replacement grease filters are available from your nearest retailer or our Genuine Parts and Accessories Mail Order Hotline (see back cover).

RELEASING THE GRILLE PANEL - To open the grille

panel press the Fig.9 catches into the

centre of the grille. The grille will be released and will fall down, pivoting to the rear (Fig.9). Remove the metal filter retainer by pulling gently, to release it from the slot in the casing.

REPLACING THE GREASE FILTER -

1.Push the wire clips to one side and remove (Fig.10).

Fig.10

2.Remove the saturated grease filter.

3.Place the new grease filter in the filter grille (Fig.11).

Fig.11

4.Replace the retaining clips.

5.Close the grille panel.

THE CARBON FILTER - (Recirculation only)

The activated carbon filter absorbs odours arising from the cooking. In use, the filter will slowly become saturated and gradually less effective. The filter will normally require changing every four months, depending on the amount and type of cooking you have done.

See page 5 (Figs. 1 and 2) to set your Cooker Hood to the recirculation option.

TO FIT THE CARBON FILTERS -

The deflector should be fixed to ensure the air flow is away from the wall to avoid dirtying or marking the rear wall (Fig.12) .

Fig.12

Place the new carbon filter, ensuring that it is aligned. to lock the filter turn in the direction of the arrow (Fig.13)

Fig.13

The Hood must not be connected to ducting when in the recirculating mode.

Regular replacement of the charcoal filter will ensure optimum performance from the hood when recirculating.

TO REPLACE THE CARBON FILTER - Remove the grille by turning the locks and pull the grille out and downwards.

Remove the saturated carbon filter by rotating it in an anti-clockwise direction and replace it with a new one.