HALOGEN BULBS
This range hood requires two halogen bulbs (Type T3, 12Volt, 20Watt Max,
WARNING: Always switch off the electricity supply before carrying out any operations on the appliance.
To change bulbs:
1.Open the cover by prying from the proper slots.
- DO NOT ROTATE.
! CAUTION: Bulb may be hot.
2.Replace with a Type T3, 12Volt, 20Watt Max,
DO NOT use bulbs greater than 20 Watts. Bulbs greater than 20 Watts will cause the fuse to open.
FUSE REPLACEMENT
IF LIGHTS FAIL TO OPERATE, DISCONNECT POWER AT THE SERVICE ENTRANCE. CHECK THE FUSE AND REPLACE IF NECESSARY.
1.Remove the grease filter and pull the visor open.
2.Locate the fuse holder on the top right hand side of the light housing.
3.Unscrew the fuse holder cap and remove the fuse.
4.Replace the fuse with the same size and amperage (5 x 20mm, 4 amp, 125 volt).
DO NOT use fuses greater than 4 Amps. Fuses greater than 4 Amps may damage the transformer.
5.Reinstall the fuse cap and grease filter. 6.Reconnect power at the service entrance.
- 5 -