Table a Adapting to different types of gas

SECTION VIEW OF THE RIGHT ASSEMBLY

Room ventilation – Location and venting.

ATTENTION: An exhaust fan may be used with the appliance; in each case it shall be installed in conformity with the national standards in force.

ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be installed in conformity with the national standards in force.

Conversion to different types of gas

Before carrying out any maintenance work, disconnect the appliance from the gas and electric supply. For Natural Gas fit regulator assembly described in Fig. 5A. For LP Gas fit assembly described in fig. 5A.

-CHANGING THE NOZZLES FOR USE WITH OTHER TYPES OF GAS: To change the nozzles of the burners use the following procedure:

Lift up the burners and unscrew the nozzles ( Fig. 6) using an adjustable spanner of 7 mm and change the nozzles with those designed for the new gas supply according to the information given in TABLE A shown below.

fig.6

TABLE A: Adapting to different types of gas

fig.7

Gas		NATURAL (A)					LP (E)

Burner	Pressure	Inj. size	Input Rate	Simmer Rate	Pressure	Inj. size	Input Rate	Simmer Rate		By-pass size
Type	[i.w.c.]	1/100mm	[BTU/h]	[BTU/h]	[i.w.c.]	1/100mm	[BTU/h]		[BTU/h]	[1/100mm]

Auxiliary		0,90	3400	900		0,54	3400		900	29
Semi-Rapid		1,18	6100	1500		0,70	6100		1500	37
Rapid	4"	1,55	10400	3700	11"	0,92	10400		3700	58

Fish		1,55	10200	4000		0,92	10200		4000	61
Triple Ring		1,65	11900	5300		1,02	12300		5300	73

CAUTION: save the orifices removed from the appliance for future use

TABLE A: Adapting to different types of gas

NATURAL (A)