BEFORE YOU CALL FOR SERVICE
If the oven fails to operate:
a)Check to ensure that the microwave oven is plugged in securely. If it is not, switch off the power, remove the plug from the outlet, wait 10 seconds and plug it in again securely.
b)Check for a blown circuit fuse or a tripped main circuit breaker. If these seem to be operating properly, test the outlet with another appliance.
c)Check to ensure that the control panel is programmed correctly and the timer is set.
d)Check to ensure that the door is securely closed engaging the door safety lock system. Otherwise, the microwave energy will not flow into the oven.
IF NONE OF THE ABOVE RECTIFY THE SITUATION, THEN CONTACT AN MEA QUALIFIED SERVICE AGENT (REFER TO PAGE 12). DO NOT TRY TO ADJUST OR REPAIR THE OVEN YOURSELF.
INSTALLATION
1.Make sure that all the packing materials are removed from the inside of the door.
2.WARNING: Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealing surface, broken or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the oven and contact an MEA Qualified Service Agent (refer to page 12).
3.This microwave oven must be placed on a flat, stable surface to hold its weight and the heaviest food likely to be cooked in the oven.
4.Do not place the oven where heat, moisture or high humidity are generated, or near combustible materials.
5.For correct operation, the oven must have sufficient airflow. In an open freestanding situation, allow 20mm of space from any overhead obstruction and 10mm from a back wall and 5mm from any side walls. If more than one side of the appliance is closed in, then installation is as per a
6.Do not operate the oven without glass tray, roller support, and shaft in their proper positions.
7.Make sure that the power supply cord is undamaged and does not run under the oven or over any hot or sharp surface.
8.The power socket must be readily accessible so that it can be easily unplugged in an emergency.
9.Do not use the oven outdoors.
EARTHING INSTRUCTIONS
This appliance must be earthed. The microwave oven is equipped with a cord which has an earth wire and an earth plug. It must be plugged into a wall receptacle that is properly installed and earthed. In the event of an electrical short circuit, earthing reduces the risk of electric shock by providing an escape wire for the electric current. It is recommended that a separate circuit, serving only the oven, be provided. Using a high voltage is dangerous and may result in a fire or other accident causing damage to the oven.
WARNING: Improper use of the earthing plug can increase the risk of electric shock.
Notes: 1. If you have any questions about the earthing or electrical instructions, consult an MEA Qualified Service Agent (refer to page 12).
2.Neither the manufacturer nor the distributor can accept any liability for damage to the oven or personal injury resulting from failure to observe the electrical connection procedures.
THE WIRES IN THIS MAINS CABLE ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
Green and Yellow = EARTH
Blue = NEUTRAL
Brown = LIVE
4