Best EB9, EB6 manual Specifications, Plan the Installation, ALL Installations

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELEC- TRIC SHOCK, OR INJURY TO PER- SONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have ques- tions, contact the manufacturer at the address or telephone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on acciden- tally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by a qualified person(s) in accor- dance with all applicable codes and stan- dards, including fire-rated construction codes and standards.

4.Sufficient air is needed for proper com- bustion and exhausting of gases through the flue (chimney) of fuel burning equip- ment to prevent backdrafting. Follow the heating equipment manufacturer's guide- line and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE),

WARNING

5.When cutting or drilling into wall, or ceil- ing, do not damage electrical wiring or other hidden utilities.

6.Ducted fans must always be vented to the outdoors.

7.To reduce risk of fire, use only metal ductwork.

8.This unit must be grounded.

CAUTION

1.For general ventilating use only. Do not use to exhaust hazardous or explosive material and vapors.

2.To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

3.Please read specification label on prod- uct for further information and require- ments.

4.Electrical circuit, including speed con- trol, (if used), must be rated 6 AMPS minimum for Model EB9 or 3 AMPS minimum for Model EB6.

INSTALLER: Leave This Manual With The Homeowner.

HOMEOWNER: Use And Care Information On Page 4.

SPECIFICATIONS

	MODEL	VOLTS	AMPS	CFM		DUCT SIZE
	EB6	120	2.4	600		10 " DIA.
	EB9	120	5.7	900		10" DIA.
PLAN THE INSTALLATION					PLAN THE INSTALLATION

ALL INSTALLATIONS

1.Locate the blower so the length of the duct run and number of elbows are kept to a minimum.

2.Where possible, blower should be cen- tered between wall studs or roof rafters.

3.Avoid pipes, wires, or other ductwork that may be running through the wall.

4.Attach mounting plate to top of hood.

5.Install 10” dia. ductwork and 120 VAC house wiring between blower location and hood location.

2