Leveling

Install right side panels on both ovens. Connect the piping between the top oven and bottom oven. Pipe joint compound must be resistant to the action of propane gases.

The manual gas valve at the bottom of the control panel should remain off until all electrical connections are made and the ovens are checked or used.

Once the oven is in its permanent position, place a carpenter's level on the oven rack. If the oven is installed on legs, turn the adjustable feet in or out to level oven front-to-back and side-to-side. If the oven is installed on casters, loosen set screws and turn casters in or out to level oven front-to-back and side-to-side. Retighten set screws after leveling.

CHIMNEY

LONG FLUE

EXTENSION

RIGHT ANGLED

FLUE EXTENSION

PL-52221

Fig. 4

ELECTRICAL CONNECTIONS

Electrical and grounding connections must comply with the applicable portions of the National Electrical Code and/or other local electrical codes.

Appliances equipped with a flexible electric supply cord are provided with a three-prong grounding plug. It is imperative that this plug be connected into a properly grounded three-prong receptacle. If the receptacle is not the proper grounding type, contact an electrician. Do not remove the grounding prong from this plug.

The 120 volt models are equipped with a cord and plug.

Refer to electrical wiring diagram located inside the right side panel; remove control panel for access.

Do not turn the power supply on until after the gas connections have been made and checked for leaks.

ELECTRICAL DATA

				Minimum Circuit Ampacity
Model	Volts	Hertz	Phase	Maximum Protective Device
				AMPS

	120	60	1	15

WKGHD	200-240	50	1	15

	208-240	60	1	15

WKGHC	120	60	1	15

	200-240	50/60	1	15
	200-240	50/60	1	15

– 6 –