Vermont Casting VCS4017 user manual Attach the Handle to the Door Parts Required

Page 6

VCS4007 / VCS4017 / VCS4027 / VCS4037 / VCS5007 / VCS5017 / VCS5027 / VCS5037 Assembly

Step 12: Attach the Handle to the Door

Parts Required:

VCS4007/VCS4017/VCS4027/VCS4037: (1) Handle

VCS5007/VCS5017/VCS5027/VCS5037: (3) Handles

Note: Handles may not appear exactly as shown in diagram

Attach the Door handle(s) to the door(s) by aligning the handles over the holes and inserting the screws that were supplied with the handles through the door panel and into the handles. For models VCS5007,VCS5017,VCS5027

&VCS5037, attach the drawer handle using the same method.

Note: If doors are not aligned or have shifted during shipping, they can be adjusted by loosening the screws which fasten the hinge of the door to the grill body and shifting the doors until they are aligned. Once satisfied with alignment, fully tighten the screws to secure the doors into position.

Step 13: Install the Grease Cup and Grease Pan

Parts Required:

(1)Grease Cup

(1)Grease Pan

Install the Grease Cup into the cut-out in the Upper Base Panel located underneath the grill. It is accessible from the back of the grill. Once the Grease cup is in place, move the Grease pan into position above it by placing the side edges onto the support rails and sliding it into place.

Fig. 13

Note: Make sure the funnel opening of the grease pan is positioned over the Grease Cup.

Step 14: Attach Stabilizer Bracket

Parts Required:

(2)#10-24 x 1/2” Bolts (black)

(1)Stabilizer Bracket

Attach the Stabilizer Bracket underneath the bottom panel by aligning the holes and inserting both #10-24 x 1/2” bolts through the panel and into the Stabilizer Bracket as shown in Fig. 14.

Stabilizer Bracket Fig. 14