Unpacking (Continued)
3.Carefully remove cabinet from carton by lifting out unit using straps provided.
CAUTION: Do not attempt to lift this air curtain by its louver or damage may result.
4.Unscrew six (6) knurled nuts and remove air intake grille. (See Figure 3.)
Figure 3 - Removing Air Intake Grille
5.Carefully disconnect motor electric cord plug assembly and remove two wing nuts on blower base. (See Figure 4.)
Figure 4 - Removing Motor/Blower Assembly
6.To remove motor/blower assembly, lift from rear of motor housing to prevent damage and misalignment to shaft and blower wheels.
NOTE: Unit is shipped with styrofoam motor support block which must be discarded at this time.
NOTE: After unpacking unit, inspect carefully for any damage that may have occurred during transit. Check for loose, missing or damaged parts.
General Safety Information
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS OBSERVE THE FOLLOWING:
1.Use this unit only in the manner intended by the manufacturer. If you have questions contact the manufacturer.
2.Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally.
3.Installation work and electrical wiring must be done by qualified persons in accordance with all applicable codes and standards, including fire rated construction.
4.When cutting or drilling into wall or ceiling, do not damage electrical wiring or other hidden utilities.
5.Make certain that the power source conforms to the electrical requirements of the unit. Disconnect power before installing or servicing. If the power disconnect is out of sight, lock it in the open position and tag it to prevent unexpected application of power. Failure to do so could result in fatal electrical shock.
WARNING: DO NOT DEPEND UPON A THERMOSTAT OR OTHER SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN INSTALLING OR SERVICING THE UNIT. ALWAYS DISCONNECT POWER AT THE MAIN CIRCUIT BREAKER AS DESCRIBED ABOVE. FAILURE TO DO SO COULD RESULT IN FATAL ELECTRIC SHOCK.
6.All wiring should be done by a qualified electrician, using copper wire only and in accordance with the National Electrical Code (NEC), all applicable code and ordinances, and all sections of this manual. Any variance voids the warranty and may create unsafe conditions.
7.Special attention must be given to any grounding information pertaining to this product. To prevent the risk of electrocution, the unit must be securely and adequately grounded. This should be accomplished by connecting a grounded conductor between the service panel and the grounding lug or green lead wire provided in the wiring compartment. To ensure a proper ground, the grounding means must be tested by a qualified electrician.
8.Do not insert fingers or foreign objects into the air curtain. Do not block or tamper with it in any manner while it is in operation. Do not touch it while in operation or just after it has been turned off, as some parts may be hot enough to cause injury.
9.This product must NOT be used in potentially dangerous locations such as hazardous locations where flammable, explosive, chemical laden, or wet atmospheres are present.
10.Do not attach ductwork to this product or attempt to use it as a
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS AIR CURTAIN WITH ANY SOLID STATE SPEED CONTROL DEVICE.
2