CONNECT DUCTWORK
1.Use 8" round metal duct to connect the duct collar on the hood to the ductwork above.
2.Use duct tape to make all joints secure and air tight.
3.Slide the lower decorative flue section downward, until it fits properly around hood.
4.Secure decorative flue to hood with mounting screws provided (3.9X9.5mm).
8” ROUND
METAL
DUCT
LOWER
DECORATIVE
FLUE
SECTION
MOUNTING
SCREWS
(3.9X9.5mm)
MAINTENANCE
Grease Filters
The grease filters should be cleaned fre- quently. Use a warm detergent solution. Grease filters are dishwasher safe.
Remove filters by pushing filters towards the back of hood and rotating filters downward.
Hood Cleaning
GREASE FILTERS
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its fine appearance.
Cleaning tips:
•Hot water with soap or detergent is all that is usually needed.
•Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
•For discolorations or deposits that persist, use a
•For stubborn cases, use a plastic scouring pad or soft bristle brush together with cleaser and water. Rub lightly in direction of polishing lines or "grain" of the stainless finish. Avoid using too much pressure which may mar the surface.
•DO NOT allow deposits to remain for long periods of time.
•DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing rust.
•DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel for extended periods. Many of these com- pounds contain chemicals which may be harmful. Rinse with water after expo- sure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
- 8 -