Kramer Electronics rk-1utb specification

Install the Kramer RK-1UTB/T Under the Table Enclosure

5Install the Kramer RK-1UTB/T Under the Table Enclosure

To install the RK-1UTB/Tyou have to:

•Mount the Kramer devices on the RK-1UTB/T(see section 5.1)

•Attach the RK-1UTB/Tunder the table (see section 5.2)

•Install the cables (see section 5.3)

This section also describes how to:

•Mount units that do not have underside screw holes (see section 5.4)

•Connect a blank panel (see section 5.5)

5.1Mount the Kramer devices on the RK-1UTB/T

The example illustrated in Figure 1 shows the TP-120ODKramer TOOL with the Kramer 1/4U TP-953.

5.1.1Installing a Kramer TOOL

To mount a Kramer TOOL do the following:

1.Remove the two TOOL M3x6 side screws1.

2.Attach the “L” shaped bracket to the TOOL and screw in the appropriate hole to the right side panel2 of the TOOL (see Figure 3).

Figure 3: Attaching the “L” Shaped Bracket

1 In some TOOL models, two M3x6 screws are attached to the sides of the Tool and can be used to fasten the brackets. Otherwise, ignore this step, use the side screws supplied with the kit, and continue to step 2

2 With front panel facing you