Zanussi ZCM 650, ZCM 651 manual Fitting the Stability Bracket Not supplied, Connecting to Gas

Page 32

 

 

300 mm.

 

 

WALL FACE

 

 

 

 

 

 

 

BACK OF COOKER

580 mm.

mm.

 

 

ENGAGEMENT EDGE FOR

LEVELLING FEET

 

STABILITY BRACKET

 

100

 

 

 

 

 

 

 

 

A

BASE OF COOKER

 

 

 

 

 

PENCIL LINE ON THE FLOOR

 

 

 

 

 

295 mm.

 

 

 

PLAN VIEW OF THE COOKER

 

SIDE VIEW

FO 0179

 

OF THE COOKER

 

 

 

 

Fig. 2

Fitting the Stability Bracket (Not supplied)

If the cooker has to be installed with a flexible supply pipe, it is necessary that a stability device is fitted. (See "Important Safety Requirements").

The stability bracket should be fitted by the installer and these instructions should be read in conjunction with the leaflet packed with the stability bracket.

Place cooker in its intended position and level cooker.

Mark off 295mm (11 1/2") from the right hand side of the cooker as shown, this is the centre line of the bracket fixing.

Draw a line 100mm (4") from the front edge of the levelling feet (see Fig. 1) and remove cooker from its position. Mark off 580mm (23") back from this line on the centre line of the bracket to locate the front edge of the lower bracket.

Fix lower bracket (with two fixing holes) to the floor, then measure height from floor level to engagement edge on back of cooker, dimension 'A' of Fig. 2.

Assemble upper bracket to lower bracket so that underside of bracket is dimension 'A' +3mm (1/8") above floor level. Re-position cooker and check that top bracket engages into cooker back to a depth of 75mm (3"), as shown in Fig. 2.

Should the stability bracket currently installed not allow the cooker to stand correctly, ask the installer to replace it with the correct type.

Connecting to Gas

This cooker is designed to be installed with an appliance flexible connection. Connection is made to the RC 1/2 (1/2" B.S.P.) threaded entry pipe located just below the hotplate level on the rear right-hand side of the cooker. Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig. 3. Take into account that it must be possible to pull the cooker forward sufficiently. The hose must not get caught on the stability bracket.

Note:

If using different types of gas bayonet connection, it may not be possible for the appliance to be pushed fully back to the wall stops.

Important:

Flexible tubing MUST comply with BS.669 Current Edition.

600

 

 

450

 

130

FO 0180

Fig. 3

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Mixed Fuel Cookers Page Important Safety Information Contents Oven Cavity AccessoriesControl Panel Gas Hob Controls Time/Temperature Control knob Safety ThermostatElectric Oven Oven Function Control KnobHow to set the time of day To reset the correct time of dayElectronic programmer Oven will work only if the time of day has been setTemperature level indicators Special functionsHeating up for the first time Using the ceramic hob for the first timeBefore the First Use of the Cooker To cancel the minute minder Programming the OvenMinute minder function To set the minute minderHow to make the oven switch off automatically To cancel the duration timeTo set the duration time To change the duration timeHow to make the oven switch on and off automatically Safety and Energy saving functions Safety Cut-Off FunctionChild Safety Function How to switch off the displayUsing the Oven Hints and TipsUsing the Conventional Oven How to Use Conventional OvenTop oven element only Hints and TipsCooking Chart Conventional Oven Temperature Cooking time Position MinutesPizza Oven Pizza OvenHow to Use the Full Grill How to Use the Inner GrillGrilling GrillingDefrosting How to Use DefrostingDefrosting Chart Maintenance and Cleaning Hob TopPan Supports BurnersCleaning the Oven Cleaning materialsExternal cleaning Pyrolytic cleaningHow to use the pyrolytic clean- ing function Page Cleaning The Oven Door Extract the inner glass supportOven lamp replacement Disconnect the appliance from the electricity supplySymptom Solution Something not workingService and Spare Parts Customer Care Department0870 5 Customer Care DepartmentGuarantee Conditions Zanussi-Electrolux Guarantee conditionsExclusions European Guarantee This guarantee does not coverInstructions for the Installer Important Safety RequirementsThis appliance cannot be positioned on a base InstallationPositioning the Appliance Fig Connecting to Gas Fitting the Stability Bracket Not suppliedMin. size Cable/flex Supply Cable SpecificationsElectrical connections Procedure To adjust the gas rateCommissioning Conversion from Natural Gas to LPG79 kWh 78 kWh 43 min 41 min 1130 cm² Customer Care

ZCM 651, ZCM 650 specifications

The Zanussi ZCM 650 and ZCM 651 are two exceptional gas cookers designed to elevate your cooking experience with their innovative features and reliable performance. Both models represent Zanussi's commitment to quality, providing users with versatile cooking options in a stylish, functional package.

One standout feature of the ZCM 650 and ZCM 651 is their powerful gas burners. These efficient burners are designed to provide quick and even heat distribution, allowing you to simmer, boil, or fry with ease. With multiple burner sizes, users can choose the right burner for their cooking needs, from small pots to large pans, ensuring that every meal is prepared to perfection.

Both models come with an integrated oven that boasts various cooking modes, including conventional and grill options. This versatility allows users to prepare a wide range of dishes, from perfectly roasted meats to delightful baked treats. The oven's spacious capacity accommodates multiple trays, making it ideal for family meals or entertaining guests.

Another notable characteristic is the easy-to-use control panel. The intuitive knob controls provide precise temperature settings for both the burners and the oven, ensuring that you have full control over your cooking process. Moreover, the ZCM 650 and ZCM 651 feature flame failure safety devices, which automatically cut off the gas supply if the flame goes out, enhancing kitchen safety.

Cleaning is made effortless with the enamel-coated oven interior in both models. This finish protects against spills and stains, allowing for quick and easy maintenance after cooking. The removable oven door also contributes to easy cleaning, ensuring every part of the cooker is accessible.

The design of the ZCM 650 and ZCM 651 reflects modern aesthetics with their sleek finish and streamlined appearance. They are available in various colors, allowing you to choose one that best fits your kitchen décor. Additionally, the compact size of these cookers makes them suitable for both small and large kitchens.

In summary, the Zanussi ZCM 650 and ZCM 651 gas cookers combine performance, safety, and style. With their efficient burners, multiple cooking modes, and user-friendly features, these models cater to the needs of home cooks while enhancing the overall kitchen experience. Whether you are a novice or a seasoned chef, these cookers are designed to make your culinary tasks easier and more enjoyable.
Top Page Image Contents