Listing Approvals, Product Dimensions Specifications

SAFETY INFORMATION

Continued

12.Always disconnect the unit from the power supply before performing any cleaning, light bulb replacement, maintenance, relocating the heater or when the unit is not in use for long periods of time.

13.When transporting or storing the unit, keep it in a dry location, free from dust, excessive vibration or other factors, which may damage the unit.

LISTING APPROVALS

This heater has been tested in accordance with the CSA Standards for ﬁxed and location-dedicated electric room heaters in the United States. All components are UL or CSA safety certiﬁed.

If you need assistance during installation, please con- tact your local dealer or the DESA Heating Products Technical Services Department at 1-866-672-6040.

PRODUCT DIMENSIONS &

SPECIFICATIONS

27" 15"

26"

CGESBL/VESBL Remote Controlled

27" Electric Stove

18"12.5"

UNPACKING AND

TESTING THE UNIT

Carefully remove the unit from the box. Prior to permanently installing the unit, test to make sure the unit operates properly by plugging the power supply cord into a conveniently located 120-volt grounded outlet.

CAUTION: The unit's power supply cord must be connected to a properly grounded and pro- tected 120-volt outlet. Always use ground fault protection where required by the electri- cal code.

WARNING: Do not operate the unit if it is damaged or has malfunctioned.Ifyoususpectthe unit is damaged, return the unit to an authorized service facility for examination, electrical or me- chanical adjustment or repair.

25.25"

CGESBMR/VESBMR Remote Controlled

18" Electric Stove

Figure 1 - Heater Dimensions

Frequency	60 Hz
Heater Power	1500 W
Heater Output	5000 BTUs

Power Supply	120V; 15 Amp
	Grounded, Circuit

Note: A dedicated power supply circuit is recom- mended for the unit but not required. Additional electrical appliances on the same circuit may ex- ceed the current (amperage) rating for that circuit. If after the installation of your unit, the circuit breaker trips or the fuse fails on a repeated basis, then a dedicated circuit will likely be required. Any new wiring must be done in compliance with local and national codes and other applicable regula- tions in order to reduce the risk of ﬁre, electric shock or other injuries. Therefore, it is strongly recommended that you hire a licensed electrician to complete any such work.

117190-01B