INSTALLING THE COOKER HOOD
Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown.
All installations must comply with the local authorities requirements for the discharge of exhaust air.
Incorrect installation may affect the safety of this cooker hood.
Installation Requirements
Before installation check the wall to which the cooker hood is to be fi tted for electric cables, water pipes or gas.
This cooker hood is designed to be fi xed to any vertical surface over a cooking area, and can be used in the extraction (ducted to the outside) or recirculation mode.
The installation work must be undertaken by a qualifi ed and competent person.
The manufacturer disclaims any responsibility for damage due to incorrect installation of the cooker hood or if the hood is not installed in compliance with relevant regulations controlling this type of installation.
Unpacking
Before unpacking the cooker hood position the carton with the arrows pointing upwards as illustrated on the carton.
The cooker hood is made up of the following components:
Ref Qty Product Components
11 Hood body, complete with controls, lighting, fan and fi lters.
21 Telescopic Chimney comprising:
2.11 Upper section
2.21 Lower section
91
101
151 Air outlet connector
Ref Qty Installation Components
7.12 Hood body fi xing brackets
7.22 Upper chimney wall fi xing brackets
12c | 6 | Chimney fi xing screws |
12d | 2 | Screws M4x25 |
Ref | Qty | Documentation |
| 1 | Instruction booklet |
15
2.1
2
2.2
10
9
1
7.2.1
12c
12c
12c
7.1
12d
11