Door reversal directions

1.Disconnect from the electricity supply.

2.Gently lay the fridge on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing;

3.Remove the bottom hinge (3), pin (1) and screw (2);

4.Slide out the fridge door from pin (D), unscrew the latter and then refit it on the opposite side;

5.Unscrew the foot on the left side and refit it on the opposite side;

6.Remove the two screws which mask the holes for fixing the hinge from the left hand side;

7.Refit the door and the lower hinge (turning it 180¡), the pin (1) and the screw (2) as shown in the Figure;

8.Remove plugs, unscrew the handle and refit it on the opposite side.

Important

After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.

	1
	3
	2
°
180	2
D299

D590

D336

Printed on recycled paper