Zanussi ZERB 9043 manual Maintenance, Appliance and environment, Defrosting

Page 9

The appliance and environment

This appliance does not contain gases which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities.

The materials used on this appliance marked with the

sympol are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chambers in form of frost and ice goes with the operation of the appliance.

Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases in the cooling chambers, they need more energy.

At this type of appliance defrosting the cooling surface of the refrigerator is automatic without any external intervention.The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted - the temperature of the cooling surface goes above 0 °C due to interior heating load of the compartment, so defrosting occurs. When the surface temperature of the cooling surface has reached +3 - +4 °C the thermostatic control restarts operation of the system.

Melting water flows through defrost water outlet leaded through the back into the evaporator tray maintained on the top of compressor and evaporates due to its warmth.

Check and clean the outlet of melting water coming during defrosting regularly - a label inside the appliance warns you for this. If

it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance.

Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The pipe scraper has to be stored in the outlet.

The most typical case of clogging up in the melting water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of the refrigerator and freezes to it. If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful - because of the above

-when placing foods wrapped in paper into the appliance.

9

Image 9
Contents 200370064 ZE/16 ZanussiSymbols below help you to find things more easily Important Safety Instructions Contents Description of the appliance, main parts General informationControlling the temperature, setting Switch and indicator setHandling the appliance Putting it into useHow to use the refrigerator Storage time and temperature of foodsStoring in the refrigerator This way the unnecessary frost building up can be avoidedHow to use the freezer Some useful information and adviceHints and ideas When placing foods wrapped in paper into the appliance MaintenanceAppliance and environment DefrostingPage Regular cleaning Trouble shootingHow to change the bulb If something does not workProblem Possible cause Solution Service and Spare Parts Customer Care Department08705 This Guarantee does not cover Guarantee ConditionsInstructions for the Installer Technical dataInstalling the appliance Page Change of door opening direction Green and Yellow Electrical ConnectionBlueNeutral BrownLive 89/336 EECFoods Storage time chartMethod of packaging NotationElectrolux plc