Zanussi ZENB 2925 manual Installation, Positioning, Rear spacers

Page 15

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal directions” paragraph.

Positioning

Important

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each climate classification:

SN +10°C to + 32°C

N+16°C to + 32°C

ST +18°C to + 38°C

T+18°C to + 43°C

It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.

mm100

A mm10 NP002

B

10 mm

You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4”) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath.

Rear spacers

The plastic bag containing all relevant documentation also contains two spacers to be fitted into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in the diagram. Then turn them through 45° (arrow (A) vertical) until they lock into place.

DO NOT install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers or a tool (see figure).

A

45°

PR60

D200

15

Image 15
Contents Refrigerator Freezer Installation Important Safety InformationContents Control panel Before usingSetting the temperature OperationUse of an air circulation slider control Cool Flow Control Fresh food refrigerationPositioning the inner shelves Positioning the door shelvesMaking ice cubes Freezer compartmentFreezing fresh food Frozen food storageNormal Operating Sounds Health and Safety Guidelines Maintenance and Cleaning Symptom SolutionSomething not Working Service and Spare Parts Customer Care Department9 9 2 Exclusions Guarantee ConditionsStandard guarantee conditions European GuaranteeNET Capacity Technical SpecificationsInstallation PositioningRear spacers Green and Yellow Earth Blue- Neutral Brown- Live Electrical connectionsDoor reversal directions Shelf holdersElectrolux plc