Grizzly G0568 JYZ7adX`, GdiVidc7dai GdY7dai 6hhnHXgZl JYZ 7ZVgc\h, Hjeedgi7ZVgc\

3. ;Vb^a^Vg^oZndjghZa[l^i]i]ZWaVYZ\j^YZXdc"
igdahh]dlc^cFigure 36 & 37#
7ZVg^c\	AViZgVa6Y_#	<j^YZ7adX`
GdiVi^dc7dai	GdY7dai	6hhnHXgZl
<j^YZ
7ZVg^c\h
Figure 36#JeeZgWaVYZ\j^YZXdcigdahgZVg
	k^Zl#
	Hjeedgi7ZVg^c\
	6Y_jhibZciH]V[i7dai
		7ZVg^c\
		GdiVi^dc
		7dai
@cjgaZY
@cdW
Figure 37.JeeZgWaVYZ\j^YZXdcigdah[gdci
	k^Zl#
4. AddhZci]ZaViZgVaVY_jhibZcigdYWdai!addh"
Zci]ZhjeedgiWZVg^c\VY_jhibZcih]V[iWdai!
VcYVY_jhii]ZWaVYZ\j^YZhjci^ai]ZZY\Zhd[
i]ZWZVg^c\hVgZ&$&+WZ]^cYi]ZWaVYZ\jaaZih!
Vh^aajhigViZY^cFigure 38#

Note: The 1/16" spacing is ideal, although with larger blades it may not be possible. In such cases, adjust the guide bearings as far for- ward to the blade gullets as possible, and still maintain the proper support bearing spacing adjustment.

7aVYZ

<jaaZi

Figure 38.AViZgVaVY_jhibZcid[WaVYZ\j^YZh#

NOTICE

Make sure that the blade teeth will not con- tact the guide bearings when the blade is against the rear support bearing during the cut or the blade teeth will be ruined.

5. I^\]iZci]ZaViZgVaVY_jhibZcigdYWdai#

6. AddhZc i]Z WZVg^c\ gdiVi^dc Wdaih dc Wdi] h^YZhd[i]ZWaVYZ#

7. GdiViZi]Z`cjgaZY`cdWhidedh^i^dci]ZWZVg" ^c\h%#%%)VlVn[gdbi]ZWaVYZ#

Note: 0.004" is approximately the thickness of a dollar bill.

8. I^\]iZc Wdi] d[ i]Z i]Z WZVg^c\ gdiVi^dc VY_jhibZciWdaihidadX`i]ZWaVYZ\j^YZWZVg" ^c\h^cedh^i^dc#

NOTICE

Whenever changing a blade or adjusting ten- sion and tracking, the upper and lower blade support bearings and guide bearings must be properly adjusted and locked before cut- ting operations.

BdYZa<%*+-$<%*+.B[\#&%$%)  "(&"