Assembly
To assemble the cement mixer:
1.Insert the wheels on the axles and secure them in place with the hairpin cotter pins, as shown in Figure 3.
������������
�������
����������
�����
Figure 3. Wheels installed on axles.
3.Connect the upper and lower plunger rods together with an M6-1 x 25 hex bolt and M6- 1 lock nut, then insert the cotter pin where shown in Figure 5. Bend each leg of the cot- ter pin outward so it can't fall out.
�����
�����������
��������
���������
| �������� |
����� | ���� |
| |
����������� | ���������� |
|
Figure 5. Plunger rod installation.
4.Attach the axle bracket to the frame with two M8-1.25 x 65 hex bolts on one side and two 8mm flat washers, lock washers, and hex nuts on the other side (Figure 6).
2.Attach the support leg to the frame with two M8-1.25 x 65 hex bolts on one side and two 8mm flat washers, lock washers, and hex nuts on the other side (Figure 4).
�������� | ��������������� |
������������ | ��������������� |
|
��������
������������
�����������
���
�����������
���
�������
�������
���������������