Grizzly H8172 owner manual Bearing block installed over shaft Attached to frame

5.With the help of another person, place the lower drum on the frame assembly, as shown in Figure 7. The gear guard MUST remain installed on the lower drum. If, for any rea- son, it is not installed in the location shown in Figure 7, then install it now.

7.Place the upper bracket over the pivot shaft, and attach the upper bracket to the frame with two M8-1.25 x 20 hex bolts on one side and two 8mm flat washers, lock washers, and hex nuts on the other side (Figure 9).

Gear Guard

Figure 7. Lower drum on frame.

6.Attach the bearing block to the frame with one M8-1.25 x 60 hex bolt on one side and one 8mm flat washer, lock washer, and hex nut on the other side (Figure 8).

Hex Bolt

M8-1.25 x 60

Figure 8. Bearing block installed over shaft and

attached to frame.

-10-

Figure 9. Upper bracket installed.

8.Attach the lower end of the mixing blades to the lower drum, placing a plastic washer between the mixing blade and the drum mounting holes (Figure 10). At each attach- ment, use an M10-1.5 x 20 Phillips head screw on one side and a 10mm flat washer, lock washer, and hex nut on the other side. Leave the fasteners loose for now.

Note: Since these fasteners will be regu- larly exposed to water, we suggest coat- ing them with anti-seize or bearing grease before assembly to prevent them from rusting together. Repeat this process on the fasten- ers used in Steps 9–10, as well.

Figure 10. Lower end of mixing blades attached

to lower drum.

H8172 Cement Mixer