Faber Inca Pro 38 installation instructions For Installations with Liners, Duct Transition Kit

TOOLS NEEDED FOR INSTALLATION	OPTIONAL ACCESSORIES AVAILABLE
• Saber Saw or Jig Saw	• Duct Transition Kit
• Drill	optional kit, transitions two 6" round openings to one 10" round
• 1 1/4" Wood Drill Bit	opening
• Pliers	part # 620000087
• Phillips Screwdriver	• *Charcoal Filters (Order 2 Kits)
• Wire Stripper or Utility Knife
• Metal Snips	* it is highly recommended that professional style cooking always
• Measuring Tape or Ruler	be vented to the outside; for recirculating installations only, some
• Level	ductwork is required to exhaust the unit out of the cabinet.
• Pencil	part # 6093034
• Caulking Gun	YOU MUST ORDER TWO OF PART #6093034 (ONE KIT FOR
• Duct Tape	EACH OF THE TWO INCA PRO MOTORS)
PARTS SUPPLIED FOR INSTALLATION	• Liners
• 2 Backdraft Dampers	Create a perfectly-sealed, non-combustible perimeter around the
• 1 Literature Package	Inca Pro 38. Depth adjustable from 21” - 25”.
PARTS NEEDED FOR INSTALLATION	ProLiner 42 Stainless - part # 620000302
	ProLiner 48 Stainless - part # 620000303
• 2 Conduit Connectors
• Power Supply Cable
• Screws to Reinforce Atttachment
• Scews for Field Wiring Box
• 1 or 2 Wall or Roof Caps
• All Metal Ductwork

!WARNING

FOR INSTALLATIONS WITH LINERS

When building a custom hood, always follow all applicable codes and standards.

Inca Pro 38 can be used with custom hoods 40” wide and up.

Choose either a custom liner or our ProLiner designed for 42” and 48” wide installations. Liners create a perfectly-sealed, non-combustible finish for the underside of your custom/wood hood.

The ProLiners are made up of two sections: a larger, rear section (pre-cut out for insertion of the Inca Pro 38) and a front section for a total adjustable depth between 21" and 25".

Consider the shape, size, and weight of the Inca Pro 38 and Liner to determine the configuration of the custom/wood hood. See

RANGEHOODDIMENSIONSAND LINER DIMENSIONS on Page 4.

CUSTOM/WOOD

HOOD

INCA PRO 38

1.The custom/wood hood must have a sturdy base (3/4" plywood recommended) to accomodate the cut-out for the Inca Pro 38. The base must be recessed to accomodate the height of the Liner (see LINER DIMENSIONS on Page 4). The Liner attaches to the bottom of the base using screws appropriate for the size and material of your custom/wood hood. The Inca Pro 38 inserts into the cut-out in the Liner and base.

2.Position the rear section of the Liner so that it abuts the back edge of your custom/wood hood. Using a pen, trace the outline of the pre-cut out. Remove the Liner and proceed to MAKE YOUR CUT-OUTSon Page 6. Install both sections of the Liner and proceed to INSTALL THE RANGEHOOD on Page 7.

Version 7/07 - Page 5