Faber Inca Pro 38 installation instructions USE and Care Information, Warranty & Service

Page 8

USE AND CARE INFORMATION

This rangehood system is designed to remove smoke, cooking vapors and odors from the cooktop area.

Rangehood Control Panel

The control panel is located on the right-hand side under the canopy. The position and function of each control button are indicated in FIGURE 10.

0

1

0

1

 

 

 

0

1

2

 

 

 

 

 

 

 

 

 

 

 

 

 

 

L MV

FIGURE 10

Light On/Off Button ( L )

On/Off switch for the halogen lights. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.

Blower On/Off Button ( M )

On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it OFF.

Blower Speed Button ( V )

Speed control for blower. Move the switch to position 1 for LOW Speed, 2 for MEDIUM speed and 3 for HIGH speed.

For Best Results

Start the rangehood several minutes before cooking to develop proper airflow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.

Cleaning

The stainless steel grease filters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Clean exterior sur- faces with a commercially available stainless steel cleaner. Abrasives and scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces.

WIRING DIAGRAM

• This rangehood uses 45 watt Halogen Lamps.

Replacing the Halogen Lamp

Before you begin, make sure that the rangehood is turned off and that the other lamps have had sufficient time to cool. Halogen lamps burn extremely hot and serious injury could result from touching a hot lamp. Press and twist the lamp to remove. If this is difficult for you, you can remove the stainless bezel which is held in place by two screws (A in FIGURE 11). Remove the two screws and the bezel. Then remove the lamp and replace with a new lamp. Once the new lamp is in place, reinstall the bezel.

A

FIGURE 11

WARRANTY & SERVICE

All Faber products are warranteed against any defect in materials or workmanship for the original purchaser for a period of 1 year from the date of original purchase. This warranty covers labor and replacement parts. The warranty does not cover consumable parts such as filters and light bulbs. This warranty does not apply if this product has been subjected to faulty installation, misuse, or neglect. This warranty excludes any consequential expense or damage resulting from any use or malfunction of the product. All implied warranties are limited to the duration of this warranty.

To obtain warranty service, contact the dealer from whom you purchased the rangehood, or the local Faber distributor. If you cannot identify a local Faber distributor, contact us at (508) 358-5353 for the name of a distributor in your area.

Version 7/07 - Page 8

Image 8
Contents Lisez Bien Cette Fiche Avant Dinstaller LA Hotte Read and Save These InstructionsVenting Requirements DuctworkElectrical Requirements For residential use onlyUniquement pour usage menager Règlements DévacuationFiche Technique Électrique Rangehood Dimensions / Dimensions DE LA Hotte Inca PRO Liner Dimensions / Dimensions DU CadreFor Installations with Liners Duct Transition KitRecirculating Installations Plan Your DuctworkMake Your CUT-OUTS CUT-OUTInstall the Rangehood Warranty & Service USE and Care InformationInstallations Avec Cadres Dimensions DE LA Hotte ET Dimensions DU Cadre à laFaire LA Coupe Installation Pour Recirculation DairPlan DU Conduit De la vers lavant Installation DE LA HotteTombe pas sur la table de Garantie ET Service Utilisation ET Entretien