Harbor Freight Tools 92390 manual Operating Instructions, INSPECTION, MAINTENANCE, and Cleaning

6.Insert the threaded portion of the Large Knob (10) through the top portion of the Handle (2) and into the open end of the Mixer Blade (7). Then, screw the Large Knob into the open end of the Mixer Blade to secure the Mixer Blade in place.

(See Figure A.)

OPERATING INSTRUCTIONS

1.NOTE: When mixing ground or minced meat, make sure to remove all bones prior to mixing.

2.Place the Plastic Cover (6) securely on top of the Tank (11). Do not remove the

Plastic Cover throughout the mixing process. (See Figure A.)

3.While turning the Handle (2) clockwise, drop a handful of meat through the slot in the Plastic Cover (6).

4.Continue turning the Handle while dropping meat through the slot in the Plastic Cover until you are finished. IMPORTANT: Allow the Mixer Blade (7) to mix slowly. (See Figure A.)

5.When finished, remove the Plastic Cover (6). Then, remove the meat.

(See Figure A.)

INSPECTION, MAINTENANCE, AND CLEANING

1.Before each use: Inspect the general condition of the Meat Mixer. Check for misalignment or binding of moving parts, cracked or broken parts, and any other condition that may affect its safe operation. If a problem occurs, have the prob- lem corrected before further use. Do not use damaged kitchen appliances.

2.To clean: Before using, and after using this product, immerse all parts of the Meat Mixer in warm, clean water and thoroughly wash with an anti-bacterial detergent.

3.When storing, make sure to store the Meat Mixer in a clean, dry, safe location out of the reach of children.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTA- TION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFAC- TURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 92390 For technical questions, please call 1-800-444-3353 PAGE 6