WARRANTY & SERVICE
All Faber products are warranteed against any defect in materials or workmanship for the original purchaser for a period of 1 year from the date of original purchase. This warranty covers labor and replacement parts. The warranty does not cover consumable parts such as filters and light bulbs. This warranty does not apply if this product has been subjected to faulty installation, misuse, or neglect. This warranty excludes any consequential expense or damage resulting from any use or malfunction of the product. All implied warranties are limited to the duration of this warranty.
To obtain warranty service, contact the dealer from whom you purchased the rangehood, or the local Faber distributor. If you cannot identify a local Faber distributor, contact us at (508) 358- 5353 for the name of a distributor in your area.
WIRING DIAGRAM |
• This rangehood uses 20 watt halogen lamps.
FUSE REPLACEMENT
Fuse model 5x20 5A
1.Remove the filters
2.Remove the screws fixing the fuseholder box
3.Open the fuseholder (bayonet fixing)
4.Replace the fuse with another of the same type
5.Replace the fuseholder box and filters
USE AND CARE INFORMATION
Thisrangehoodsystemisdesigned toremovesmoke,cooking vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop proper airflow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Rangehood Control Panel
The control panel is located on the
L MV
FIGURE 13
Light On/Off Button ( L )
On/Off switch for the halogen lights. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Speed control for blower. Move the switch to position 1 for LOW Speed, 2 for MEDIUM speed and 3 for HIGH speed.
For Best Results
Start the rangehood several minutes before cooking to develop proper airflow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Clean exterior surfaces with a commercially available stainless steel cleaner. Abrasives and scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces.
Replacing the Halogen Lamps
Before you begin, make sure that the rangehood is turned off and thattheotherlampshavehadsufficienttimetocool. Halogenbulbs burn extremely hot and serious injury could result from touching a hot bulb. To replace the lamp, the bezel (A) around the lamp(C) must be removed as indicated in FIGURE 14. This bezel (A) is held in place by two screws (B). Remove the two screws and the bezel. Then remove the lamp and replace with a new lamp. Once the new lamp is in place, reinstall the bezel.
FIGURE 14
Version 01/05 - Page 7