Faber 630003952 installation instructions USE and Care Information

Page 8

USE AND CARE INFORMATION

This rangehood system is designed to remove smoke, cooking vapors and odors from the cooktop area.

Rangehood Control Panel

The control panel is located on the right-hand side under the canopy. The position and function of each control button are indicated in FIGURE 11.

Replacing the Halogen Lamp

Before you begin, make sure that the rangehood is turned off and that the other lamps have had sufficient time to cool. Halogen lamps burn extremely hot and serious injury could result from touching a hot lamp. Press and twist the lamp to remove. If this is difficult for you, you can remove the stainless bezel which is held in place by two screws (A in FIGURE 12). Remove the two screws and the bezel. Then remove the lamp and replace with a new lamp. Once the new lamp is in place, reinstall the bezel.

L MV

FIGURE 11

Light On/Off Button ( L )

On/Off switch for the halogen lights. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.

Blower On/Off Button ( M )

On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it OFF.

Blower Speed Button ( V )

Variable Speed control for blower. Move the switch from the left to the right (LOW to HIGH speeds).

For Best Results

Start the rangehood several minutes before cooking to develop proper airflow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.

Cleaning

The stainless steel grease filters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Clean exte- rior surfaces with a commercially available stainless steel cleaner. Abrasives and scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces.

WIRING DIAGRAM

HALOGEN LAMPS

FIGURE 12

• This rangehood uses 45 watt Halogen Lamps.

Version 03/08 - Page 8

Image 8
Contents Lisez Bien Cette Fiche Avant Dinstaller LA Hotte Inca PRO 30 RBVenting Requirements DuctworkElectrical Requirements For residential use onlyRèglements Dévacuation Le système dévacuation Doit sortir à lextérieurFiche Technique Électrique Uniquement pour usage menagerPeut être employée les hottes encastrable sur mesure de For Installations with Liners Inca Pro 30 can be used with custom hoods 30 wide and upMake Your CUT-OUTS CUT-OUT Install the RangehoodPlan Your Ductwork Volt white supply wire Remove the two philips screws D in . Remove the entireUSE and Care Information Faber Warranty & Service Save for Your Records Installation DE LA Hotte à la Installations Avec CadresDimensions DE LA Hotte ET Dimensions DU Cadre à la CUT-OUT Plan DU ConduitFaire LA Coupe Installation DE LA Hotte Utilisation ET Entretien Enregistrez Votre Information Ci-dessous