Maintenance and cleaning, Cleaning the filters

Maintenance and cleaning

Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....).

Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.

Under no circumstances may the dishwasher be used without filters.

Incorrect repositioning and fitting of the filters will produce poor washing results.

We recommend every 3 months to run a 65°C wash programme without dishes using detergent.

Cleaning the filters

The filters in the base of the washing compartment are to a large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. Dirty filters will degrade the washing result.

1.	Open the door, remove the lower basket.
2.	The dishwasher filter system comprises a coarse/fine filter

NEVER try to remove the upper spray arm.

If residues of soil have clogged the holes in the upper spray arm, remove them with a toothpick.

MA33

(A/B), a microfilter (C) and a flat filter (D).

Some dishwasher models filter system comprises only a

coarse filter (A), a microfilter (C) and a flat filter (D).

Unlock the filter system using the handle on the microfilter,

Check that the WRD is not clogged with detergent residue. If necessary rinse it under running water after having removed it from the basket by twisting it anticlockwise and pulling it upwards.

and remove.

Never use your dishwasher without the WRD dispenser. Since WRD also ensures correct distribution of the water to the upper spray arm, running the dishwasher without it will impair the washing results.

MA11

	MA32	MA35
	MA32
3.	Turn the handle
	about 1/4 a turn
	anticlockwise and
	remove.
4. Take hold of the
	coarse/fine filter
	(A/B) by the handle
	with the hole and
	remove from the
	microfilter (C).	MA15
5.	Clean all filters
	thoroughly under
	running water.
6. Remove the flat filter
	(D) from the base of
	the washing
	compartment and
	clean both faces
	thoroughly.
7. Put the flat filter (D)
	back in the base of
	the washing	MA34
	the washing	MA23
		MA23
	compartment.

8.Place the coarse/fine

filter (A/B) in the microfilter (C) and press together.

9.Put the filter combination in place and lock by turning the handle clockwise to the stop. During this process ensure that the flat filter does not protrude above the base of the washing compartment.

Prolonged periods of non-operation

If you are not using the machine for any period of time you are advised to:

1.Unplug the appliance and then turn off the water.

2.Fill the rinse aid dispenser.

3.Leave the door ajar to prevent the formation of any unpleasant smells.

4.Leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it.

Moving the machine

If you have to move the machine (moving house etc....):

1. Unplug it.

2.Turn the water tap off.

3.Remove the water inlet and discharge hoses.

4.Pull the machine out together with the hoses. Avoid over tilting the machine during transportation.