Zanussi DA 4131 manual Maintenance and cleaning

Page 13

Maintenance and cleaning

Internal cleaning

Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth.

We recommend the use of Finish Dishwasher Cleaner every 3 months or run a 65°C wash without dishes using detergent. Regular use of Finish Dishwasher Cleaner cleans inaccessible parts, eliminates unpleasant food odours and helps prevent the build-up of limescale.

Cleaning the central filter

(After each wash)

Inspect the central filters (B) and (C) and remove any scraps of food with a brush, under running water.

Filters (B) and (C) are both removed by lifting up the outer one

(B)(pulling the central funnel upwards); the smaller filter (C) can be removed by pressing the two tongues (D).

External cleaning

Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....).

Prolonged periods of non-operation

If you are not using the machine for any period of time you are advised to:

1.Unplug the appliance and then turn off the water.

2.Fill the rinse aid dispenser.

3.Leave the door ajar to prevent the formation of any unpleasant smells.

4.Leave the inside of the machine clean.

C

D

B

MA02

D

MA13

C

B

Frost precautions

Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it.

Once cleaned, refit the filters by pressing them down until they click into place.

MA08

Cleaning the large filter

(Every week)

Clean the large filter (A) on both sides under running water, using a brush.

To take it out, remove the spray arm by pressing the two tongues (E), turn the ring (F) anticlockwise and then slide the whole part out. Refit the filter following the above instructions in reverse order.

Moving the machine

If you have to move the machine (moving house etc....):

1.Unplug it.

2.Turn the water tap off.

3.Remove the water inlet and discharge hoses.

4.Pull the machine out together with the hoses. Avoid over tilting the machine during transportation.

E

A

F

MA03

E

A

F

MA01

The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results.

Cleaning the filters is vital to ensure correct operation of the machine.

5

Image 13
Contents Dishwasher Control panel Description of the applianceUsing your appliance Operating sequence Washing programmesInterrupting a washing programme in progress End of the washing programmeFitting under a counter Technical specificationsLevelling Proceed as followsCustomer Care Department Service and Spare PartsStandard Guarantee Conditions Guarantee ConditionsEuropean Guarantee ExclusionsFrom the Electrolux Group. The world’s No.1 choice Important safety information ContentsSetting the water softener Before using your dishwasher forBefore use First timeRinse aid Adjusting the doseFilling with rinse aid Use of detergentTo save energy Hints and tipsFor best washing and drying results Items not suitable for dishwashersMaintenance and cleaning Something not working Symptom SolutionWater supply connections InstallationElectrical connection Water outlet hose connection03/03