Zanussi DW 914 manual Water outlet hose connection

Page 21

Water outlet hose connection

The end of the drain hose can be connected in the following ways:

1.To the sink outlet siphon, securing it if necessary with a clip.

2.Hooked over the edge of the sink using the special curved plastic guide provided.

3.To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.

The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher.

The drain hose can face either to the right or left of the dishwasher

Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

The sink plug must not be in place when the machine is draining as this could cause the water to siphon back into the machine.

			1	2	3
	21				4cm
Ø	21		18		min
Ø					min
		Ø
		Ø
				max 100 cm	min 30 cm max 100 cm
CS09

Ø 18	Ø 21
+ 2 m max		min 30 cm max 100 cm
	max100cm	min 30 cm max 100 cm
CS10

21

COL09en

Image 21

Contents Dishwasher Contents Installation Important safety informationChild Safety During UseControl panel Description of the applianceBefore use Setting the water softenerFilling with salt Adjusting the dose Rinse aidEnsure that the lid is closed after every refill Loading your appliance Using your applianceLower basket Cutlery basketUpper basket Adjusting the height of the upper basketTo move to the higher position proceed as follows Never lift or lower the basket on one side onlyIf using detergent in tablets proceed as follows If using powder detergents proceed as followsUse of detergent Compact detergents with enzymesTo save energy Hints and tipsFor best washing and drying results Items not suitable for dishwashersWashing programmes Operating sequence Internal cleaning Maintenance and cleaningCleaning the central filters Cleaning the large filterFrost precautions External cleaningProlonged periods of non-operation Moving the machineSomething not working Customer Care Department Service and spare partsStandard guarantee conditions Guarantee conditionsEuropean Guarantee This guarantee does not coverHints for test centres Technical specificationsInstallation instructions Water supply connectionsLocknut must be correctly fitted to avoid water leaks Water outlet hose connection Electrical connection Green and Yellow -Earth Blue-Neutral Brown-LiveProceed as follows Adjusting the worktop Fitting under a counterLevelling