Zanussi DE 6854 manual Installation instructions, Fitting under a counter, Levelling

Page 17

Installation instructions

Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person.

Remove all packaging before positioning the machine.

If possible, position the machine next to a water tap and a drain.

Do not use, for connection, old hoses which have been used in another appliance.

If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose.

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.

570

-

 

600

820

 

600

 

IN05

 

Proceed as follows:

Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.

Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.

If the dishwasher is later used as a free-standing appliance, the original worktop must be re-mounted.

The plinth on free-standing appliances is not adjustable.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

Water supply connections

This dishwasher must be plumbed into a cold water supply.

The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations.

The water pressure must be within the limits given in the "Technical specifications". Your local Water Authority will advise you on the average mains pressure in your area.

The dishwasher features fill and drain hoses which can be

turned either to the left or the right to suit the installation. The locknut must be correctly fitted to avoid water leaks.

The water inlet hose must not be kinked, crushed, or entangled when it is being connected up.

Water outlet hose connection

The end of the drain hose can be connected in the following ways:

1.To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine.

2.Hooked over the edge of the sink using the special curved plastic guide provided.

3.To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.

The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher.

The drain hose can face either to the right or left of the dishwasher

Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water.

The sink plug must not be in place when the machine is draining as this could cause the water to siphon back into the machine.

If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

CS18

Attention!

Our appliances are supplied with a security device to protect against the return of dirty water back into the machine.

If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher.

We advise you therefore to remove it.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Dishwasher Contents Installation Safety instructionsChild safety DisposalPhase indicator lights Indicator lightsDescription of the appliance Control panelSetting manually Setting electronicallySetting the water softener Filling with salt Adjusting the doseTo fill Rinse aidStarts to flash Turns off. At the same time Rinse aidPress push button Again, Rinse aid DeactivatedLoading cutlery and dishes Daily useLower basket Cutlery basketUpper basket Adjusting the height of the upper basket31 cm To move to the higher position proceed as followsFill with detergent Use of detergentUse of 3 in 1 combi detergent tablets Concentrated detergentWashing programmes Setting/cancelling the Delay start Setting and starting the programmeEnd of the washing programme Unloading the dishwasherCleaning the filters Maintenance and cleaningFrost precautions Prolonged periods of non-operationThere are problems when operating the dishwasher Flashing fault code appearsFault code / malfunction Possible cause Fault Possible cause SolutionsCustomer Care Department Service and Spare PartsDishes are wet and dull Water drops have dried onto glasses and dishesStandard guarantee conditions Guarantee ConditionsEuropean Guarantee ExclusionsFitting under a counter Installation instructionsLevelling Water supply connectionsElectrical connection SymbolThis appliance must be earthed Blue- Neutral Brown- LiveType Programmes chartHints for test centres From the Electrolux Group. The world’s No.1 choice

DE 6854 specifications

The Zanussi DE 6854 is a premium dishwasher that combines efficiency, performance, and design to enhance your kitchen experience. With a sleek exterior and intuitive controls, this model is suited for modern households that demand both functionality and aesthetics in their home appliances.

One of the standout features of the Zanussi DE 6854 is its impressive capacity. Designed to accommodate up to 15 place settings, it is ideal for families and those who frequently entertain guests. The adjustable upper rack allows for flexibility when loading larger pots and pans, ensuring that every item gets thoroughly cleaned.

The DE 6854 is equipped with several wash programs to suit different cleaning needs. From intensive cleaning cycles for heavily soiled dishes to quick wash options for lightly soiled items, users can select the perfect setting for any load. The Eco program is particularly noteworthy for those looking to reduce water and energy consumption without sacrificing performance.

Zanussi has integrated advanced technologies in the DE 6854 to optimize cleaning efficiency. The innovative AirDry technology ensures that dishes come out not just clean, but also dry without the need for extra hand drying. This feature functions by automatically opening the door at the end of the cycle, allowing fresh air to circulate and effectively drying the contents.

Noise levels are often a concern for dishwashers, and the DE 6854 addresses this with a low noise operation, making it an ideal choice for open-plan living spaces. With an operational decibel rating that is well within the quiet range, this model allows users to run it at any time of day without disturbing the household.

Additional highlights of the Zanussi DE 6854 include a delay start function, which allows users to set the dishwasher to run at a more convenient time. This feature is particularly beneficial for those who want to take advantage of off-peak energy rates.

With its sleek design, smart functionalities, and efficient cleaning capabilities, the Zanussi DE 6854 offers a comprehensive solution for all dishwashing needs. It not only makes chores easier but also enhances the overall kitchen experience. Whether for daily use or special occasions, this dishwasher stands out as a reliable and stylish choice for modern homes.
Top Page Image Contents