Zanussi ZDT 6244 Wash results are not satisfactory, Dishes are not clean, Dishes are wet and dull

Page 17

...the wash results are not satisfactory

The dishes are not clean

The wrong washing programme has been selected.

The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.

The spray arms do not rotate freely due to wrong arrangement of the load.

The filters in the base of the washing compartment are dirty or incorrectly positioned.

Too little or no detergent has been used.

Where there are limescales deposits on the dishes; the salt container is empty or the wrong level of the water softener has been selected.

The drain hose connection is not correct.

The salt container cap is not properly closed.

The dishes are wet and dull

Rinse aid was not used.

The rinse aid dispenser is empty.

There are streaks, milky spots or a bluish coating on glasses and dishes

Decrease rinse aid dosing.

Water drops have dried onto glasses and dishes

Increase rinse aid dosing.

The detergent may be the cause. Contact the detergent manufacturer’s consumer care line.

If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).

This information can be found on the rating plate located on the side of the dishwasher door (see picture).

So that you always have these numbers at hand, we recommend you to make a note of them here:

Mod. : . . . . . . . . . . . . . . . . . .

PNC : . . . . . . . . . . . . . . . . . .

S.N. : . . . . . . . . . . . . . . . . . .

RA08

This product should be serviced by an authorised service engineer, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the machine yourself.

Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Force Centre.

Always insist on genuine spare parts.

17

Image 17
Contents Dishwasher Contents Installation Safety instructionsChild safety DisposalControl panel Description of the applianceFactory setting audible signals activated Audible signalsDeactivation/activation of the audible signals Audible signals Prior to using for the first timeWater softener ExampleTo fill Filling with saltFactory setting dosage of rinse aid activated Adjusting the doseRinse aid Filling with rinse aidLoading cutlery and dishes Daily useLower basket Are of limited suitabilityCutlery basket Adjusting the height of the upper basketUpper basket To move to the higher position proceed as followsFill with detergent Use of detergentDetergent tablets Different kinds of detergentConcentrated detergent Combi detergentsWashing programmes To interrupt or cancel a washing programme in progress Setting and starting the programmeStarting a washing programme Unloading the dishwasherCleaning the filters Maintenance and cleaningFrost precautions Prolonged periods of non-operationThere are problems when operating the dishwasher Flashing fault code appearsFault code / malfunction Possible cause Solutions Fault Possible cause SolutionsWash results are not satisfactory Dishes are not cleanDishes are wet and dull Water drops have dried onto glasses and dishesCustomer Care Department Service and Spare PartsStandard guarantee conditions Guarantee ConditionsEuropean Guarantee ExclusionsInstallation instructions Proceed as follows Electrical connectionGreen and Yellow Earth Blue- Neutral Brown- Live Hints for test centres Page From the Electrolux Group. The world’s No.1 choice