Zanussi ZDT 6244 manual Rinse aid, Filling with rinse aid, Adjusting the dose

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.

The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting.

Filling with rinse aid

1.Open the container by pressing the release button (A).

2.Add the rinse aid until the container is completely full. The maximum level for filling is indicated by "max".

●If you are using dishwasher detergent that already contains rinse aid, the detergent including the rinse aid must be placed in the detergent compartment.

In this case the rinse aid dosage must be deactivated in orderto avoid a double dosage.

Deactivation/activation of the dosage of rinse aid

(The dishwasher must be switched off)

Factory setting: dosage of rinse aid activated

1. Press the On/Off push button. All programme selection push

BR10

BR16

buttons indicator lights will illuminate (setting mode).

If only one programme selection push button indicator light

is illuminated, this means that a washing programme has

been selected.

The programme must be cancelled: press simultaneously

the function push buttons 2 and 3 for about 2 seconds, the

indicator light of the set programme push button starts

flashing for about 2 seconds.

After about 2 seconds the indicator lights of all the

programme selection push buttons will illuminate indicating

that the setted programme has been cancelled and that

the machine is now in setting mode.

Ensure that the lid is closed after every refill.

Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.

Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.

Adjusting the dose

According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position

6 maximum dosage).

The dose is factory set in position 4.

Increase the dose if there are drops of water or lime spots on the dishes after washing.

Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware	BR12
or knife blades.
Top up the rinse aid when the
indicator (B) becomes clear.
	BR11

2.	Press simultaneously function push buttons 2 and 3, the
	indicator lights of the function push buttons 1, 2 and 3 start
	flashing.
3.	Press the function push button 2, the indicator lights of
	function push buttons 1 and 3 turn off while the indicator
	light of the push button 2 goes on flashing, at the same time
	the END OF CYCLE indicator light illuminates, indicating
	that the dosage of rinse aid is active.
4.	To deactivate the dosage of rinse aid, press again the
	function push button 2, the END OF CYCLE indicator light
	turns off, indicating that the dosage of rinse aid has been
	deactivated.
5.	To memorise the operation, switch off the dishwasher by
	pressing the On/Off push button or wait about 60 seconds
	after which the dishwasher will automatically return to
	setting mode.

To activate again the dosage of rinse aid simply follow the above operations until the END OF CYCLE indicator light illuminates.

8