Sherwood TX-5090C Output Jacks, AM Loop Antenna Terminals, FM Indoor Antenna, FM Outdoor Antenna

Page 6

ENGLISH

OUTPUT JACKS

Connect these jacks to the TUNER INPUT jacks of your amplifier such as AX-5090R, etc.

AM LOOP ANTENNA TERMINALS

The supplied antenna is for indoor use. Place it as far as possible from the main system, TV, speaker cords and AC input cord and set it to a direction for the best reception.

FM INDOOR ANTENNA

The supplied antenna is for indoor use. Strech out the antenna fully and find the position for the best reception, then fix it.

FM OUTDOOR ANTENNA

It is recommended to install an FM outdoor antenna for very high quality FM reception.

An FM outdoor antenna can be connected to the tuner with a 75coaxial cable.

DIGI LINK JACKS

Connect this jack to the DIGI LINK jack of Sherwood amplifier such as AX-5090R,etc. bearing the DIGI LINK III or II logo to control this unit remotely by DIGI LINK system.

AC INPUT CORD

Plug this cord into the switched AC outlet of amplifier or a household AC outlet.

UNSWITCHED AC OUTLET

Power always flows to this outlet. regardless of whether this unit is switched ON or OFF if power flows through the AC input cord of this unit.

Note : The equipment whose power consumption exceeds 100 watts should not be connected.

6

Image 6
Contents TX-5090C/RDS Introduction Read this Before Operating Your Unit Contents Rear Panel Connections AM Loop Antenna Terminals Unswitched AC OutletOutput Jacks FM Indoor AntennaFront Panel Controls Digi Link System Remote Control DisplayAuto tuning Manual tuningPresetting Radio Stations When using the Preset Numeric buttons When using the Preset Scan buttonRDS search TP searchPTY search EON Ptyeon Enhanced Other Networks informationEON TA Troubleshooting Guide Problem Possible Cause RemedyAmmw Tuner Section SpecificationsFM Tuner Section Amlw Tuner Section5707-04715-002-0