Sherwood TX-5090RDS, TX-5090C manual Auto tuning, Manual tuning

Page 9

Operations

LISTENING TO RADIO BROADCASTS

Auto tuning

Turn the power on.

1

Each time the POWER switch is pressed, this unit is turned on or off.

Press the TUNING UP( ) or DOWN( )

3 button for more than 0.5 second.

This unit will now search until a station of sufficient strength has been found.

The display shows the tuned frequency and “TUNED”. If the station found is not the desired one, simply repeat this operation.

Weak stations are skipped during auto tuning.

Select the desired band.

2

Example) When selecting the FM band.

MHz

Each time the AM button is pressed, the band changes as follows;

MW LW

Manual tuning

Manual tuning is useful when you already know the frequency of the desired station.

Perform the steps 1~2 in “Auto tuning” porocedure and press the TUNING UP( ) or DOWN( ) button repeatedly until the desired frequency has been reached.

ENGLISH

LISTENING TO FM STEREO BROADCASTS

While listening to FM brodcasts, select the desired FM mode.

Each time this button is pressed, the FM mode changes as follow;

STEREO mode : “ST” lights up

MONO mode : “ST” goes off

When FM stereo broadcasts are poor because of weak brocasts signals, select the FM mono to reduce the noise, then FM broadcasts are reproduced in monaural sound.

9

Image 9
Contents TX-5090C/RDS Introduction Read this Before Operating Your Unit Contents Rear Panel Connections Output Jacks Unswitched AC OutletAM Loop Antenna Terminals FM Indoor AntennaFront Panel Controls Display Digi Link System Remote ControlManual tuning Auto tuningPresetting Radio Stations When using the Preset Scan button When using the Preset Numeric buttonsTP search RDS searchEON Ptyeon Enhanced Other Networks information PTY searchEON TA Problem Possible Cause Remedy Troubleshooting GuideFM Tuner Section SpecificationsAmmw Tuner Section Amlw Tuner Section5707-04715-002-0