Sherwood RX-4103 manual Tuning to preset stations, Memory Backup Function

3	Select the desired preset number (1~30) and			4	Repeat the above steps 1 to 3 to memorize
	press the MEMORY button.				other stations.
	MEMORY		MEMORY
TUNING/PRESET		or
When using the NUMERIC buttons on the remote				MEMORY BACKUP FUNCTION
control.	3			The following items, set before the receiver is turned
Examples) For “3” :
				off, are memorized.
	1	within 2 seconds	5
				INPUT SELECTOR settings
	For “15” :
	0			Preset stations,etc.
	For “30” :
				Note
The station has now been stored in the memory.
				If the electricity fails or the AC input cord is
When using the NUMERIC buttons, the station is
				disconnected for more than 2 weeks, they are all
stored automatically without pressing the MEMORY
				cleared. So you should memorize them again.
button.
A stored frequency is erased from the memory by
storing another frequency in its place.
If “MEMO” goes off, start again from the above step 2.
Tuning to preset stations				2	Select the desired preset number.
1	After selecting the tuner as an input				TUNING/PRESET
	source, select the preset mode.			When using the NUMERIC buttons on the remote
	T/P MODE			control.				3
				Examples) For “3” :
					For “15” :			1	within 2 seconds	5
					For “30”	:		0
Then “CH” lights up.				When selecting the desired preset number with the
				NUMERIC buttons, the desired preset station will be
				tuned to automatically without selecting the preset
				mode.
Listening to FM stereo broadcasts				Scanning preset stations in sequence
While listening to FM broadcasts.
			FM MODE		1	2	3	4
					POWER		A SPEAKER B
					5	6	7	8
					9	0	FM MODE MEMORY
					DISPLAY	SLEEP	P.SCAN	TUNER	P.SCAN
					CD	TAPE	VCR	AUX
					AUDIO CONTROL		TONE SEL
					BALANCE		MUTE	VOLUME
Each time this button is pressed,					REMOTE CONTROL UNIT RM-101
the FM mode changes as follows:
Stereo mode : “STEREO” lights up.
Mono mode : “STEREO” goes off.
When FM stereo broadcasts are poor because of				The receiver will start scanning the stations in the preset
weak broadcast signals, select the FM mono mode to				sequence and each station is received for 5 seconds.
reduce the noise, then FM broadcasts are reproduced				At the desired station, press this button again to stop
in monaural sound.				scanning.

ENGLISH

13