Sherwood RX-4103 manual System Connections, Connecting AUDIO/VIDEO Components Connecting Antennas

Page 5

System Connections

Do not plug the AC input cord into the wall AC outlet until all connections are completed.

Be sure to connect the white RCA pin cord to the L(left) and the red RCA pin cord to the R(right) jacks when making audio connections.

Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations. A 75 outdoor FM antenna may be used to further improve the reception.

Disconnect the indoor antenna before replacing it with the outdoor one.

Place the AM loop antenna as far as possible from the receiver, TV set, speaker cords and the AC input cord and set it to a direction for the best reception.

If the reception is poor with the AM loop antenna, an AM outdoor antenna can be used in place of the AM loop antenna. Make connections firmly and correctly. If not, it can cause loss of sound, noise or damage to the receiver.

If the electricity fails or the AC input cord is left unplugged for more than 2 weeks, the memorized contents will be cleared. Should this happen, memorize them again.

ENGLISH

CD

 

TV/AUX

 

TAPE

 

VCR

IN OUT IN OUT

ANTENNA

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation.

 

SPEAKERS

A

SPEAKER IMPEDANCE

 

A, B - 8 MIN / SPEAKERS

 

A+B -16 MIN / SPEAKERS

B

 

AC INPUT

120V~60Hz

2.5A

MODEL NO. RX-4103

STEREO RECEIVER

MADE IN CHINA

DESIGNED IN USA

SER. NO

CONNECTING AUDIO/VIDEO COMPONENTS

CONNECTING ANTENNAS

CD player

FM

(OUTDOOR ANTENNA)

TV or additional component

AUDIO OUT

FM

AM loop antenna

(INDOOR ANTENNA)

 

CD

TV/AUX

TAPE

VCR

IN OUT IN OUT

AM

LOOP

Tape deck

PLAY(LINE) OUT

BA

REC(LINE) IN

Video deck or MD recorder, etc.

AUDIO OUT

 

 

AUDIO IN

The VCR jacks may also be connected to an additional component such as MD recorder, tape deck, etc.

The TV/AUX jacks may also be connected to an additional component such as a TV, DVD player, etc.

5

Image 5
Contents RX-4103 Introduction Unpacking and InstallationAC Voltage Selection Read this Before Operating Your UnitContents System Connections Connecting AUDIO/VIDEO Components Connecting AntennasAC Input Cord Connecting SpeakersFront Panel & Remote Controls Input Selector Buttons Loading Batteries Remote Control Operation RangeListening to a Program Source OperationsAdjusting the sound volume balance Adjusting the tonebass and trebleManual tuning Auto tuningPresetting radio stations Listening to Radio BroadcastsMemory Backup Function Tuning to preset stationsAdjusting the brightness of the unit’s fluorescent display Operating the sleep timerRecording Other FunctionsProblem Possible Cause Remedy Troubleshooting GuideAmplifier Section SpecificationsRX-4103