Adjusting the tone(bass and treble)
9 | At the desired tone mode, adjust the |
tone as desired. |
8
Enter the tone mode.
Each time this button is pressed, the corresponding tone mode is selected and shown for 3 seconds as follows:
Note:
When the tone direct function is activated, the tone mode cannot be entered and “TON DIR” flickers for 3 seconds.
If the tone display disappears, start from the step 8 again.
Notes:
Extreme settings at high volume may damage your speakers.
In general, the bass and treble levels are adjusted to 0.
To listen to a program source without the tone
10 effect.
“TON DIR” is displayed and the sound that bypasses the tone circuitry will be heard. To cancel the tone direct function, press this button again to display “TON CTRL”.
Adjusting the sound volume balance
Enter the balance mode.
11
“BAL” and the balance level is displayed for 3 seconds.
Adjust the sound volume balance
12 between the left and right speakers.
If the balance display disappears, start from the step 11 again.
Note:
In general, the balance level is set to 0.
11