Sound Performance Lab 2710 manual Fitting Modules, Step

Page 12

Fitting Modules

Step 4 and 5

 

 

 

Step 4 (Top View)

 

 

Y

 

.0%6-&

.0%6-&

'MBUSJCCPODBCMFXJUIFJHIUQMVHTUPQPXFSUIFNPEVMFT



"8":416--0313&445)&1-6(4

 

 



/&7&35)&$"#-&

TJMWFSEFDPSBUJPOQBOFM

Y

Insert the new module into the slot from the front side of the RackPack. Fix the back of the new module with the four Phillips screws to the rear of the frame (two of the Phillips screws needed here came with the new module, two further screws remained from unscrewing the rear cover panel, see step 2).

Now tighten the two M4 socket screws. Put them through the holes on the top and bottom of the aluminum panel first, then through the top and bottom holes of the front of the module. Fix the panel and the front of the module by tightening the M4 screws into the threads of the housing (see step 3).

Step 5

Finally plug the multi-pin connector of the ribbon cable that corresponds to the module’s slot into the multi-pin socket of the new module. Make sure that the connection is safe and tight by plugging the connector completely into the socket.

IMPORTANT: Only pull or push the connector, never the cable! Otherwise you risk damaging the cable. Subsequent damages can affect one or more modules!

12

RackPack

Image 12
Contents Manual Manual RackPack, Model Version 1.0 8 /2007 Designer Wolfgang NeumannContents Important Safety Information Symbols And Notes Introduction RackPackRackPack Modules Freedom As a Matter Of PrinciplePlacement Placement Of The External Power SupplyHook Up Scope Of DeliveryPower Connection Signal ConnectionsAir Circulation On And OffRear Panel DPNTPVOEQFSGPSNBODFMBCXXXPlease Note Top ViewRear View Front ViewFitting Modules StepLink Cable Installation Top View  .0%6-& .0%6-& .0%6-&External Power Supply Dimensions & Weight GuaranteeManual RackPack