Connections
Rear view Loudness Maximizer, Model 9632
Before connecting the Loudness Maximizer switch the power off at all connected units.
The rear panel provides AES/EBU- and
The Loudness Maximizer operates with 24 bit word width. It accepts 16 bit and 20 bit inputs and will create output signals according to the input resolution.
For synchronisation purposes Wordclock In and Wordclock Through BNC connectors are fitted with a switchable 75 Ohm termination.
MIDI In and MIDI Through connectors allow presets to be selected via MIDI program change commands.
For easy upgrade of future software releases, the rear panel offers
Installing Updates:
Note: All presets will be lost after installing a new software version!
1.Connect your computer with the Loudness Maximizer via a serial port with a standard
2.Open a terminal program like “Hyperterminal” on PC and make the following adjustments:
Baud rate: 9600; Stop bit: 1; Parity: none; Data bit: 8; Handshake:
no;Transfer mode: ZMODEM
3.Switch on the Loudness Maximizer and depress both Preset Up and Preset Down until the LC- display says “wait for Zmodem download“.
4.Load the update file into your terminal program and send it to the Loudness Maximizer.The
5.After successfully installing the new software version the
6.Switch the Loudness Maximizer off and on. The new software version number is displayed in the first INFO page (simulta- neously depress Store and Apply; also refer to Control Elements No. 9, INFO).
7.If an error occurred during download the
6 | L o u d n e s s M a x i m i z e r |