Sound Performance Lab 9632 manual Quick Start, Flow Chart

All controls are in the start-off positions:

DESIRED GAIN 0; SOFT-HARD -9; MORE DENSITY 0.

1.Press ACTIVE. LED illuminates.

2.Watch the Possible LED chain and adjust the shown value with the DESIRED GAIN (for most unobstrusive operation the Possible LED chain should not show negative values.

3.If more loudness is wanted, turn the SOFT-HARD to higher

values (i. e. -3). The Possible LED chain shows you the new free loudness headroom that you ad to the previously adjusted DESIRED GAIN value.

4.To increase the density of your source material turn up the MORE DENSITY control.

Quick Start

AUDIO

signal

analysis

Possible

display

Done

display

compressor

Desired

encoder

Density encoder

limiter

Boost	Soft/Hard
switch	encoder

AUDIO

Flow Chart

The signal analysis computes control data for the Compressor and Limiter and calculates the Possible as well as the Done loudness increase

Possible:The LED bar shows the possible loudness increase

Done:The LED bar shows how much % of the DESIRED GAIN have been realized

The Compressor operates with a static (no-knee) characteristic for most unob- strusive compression

DESIRED GAIN: Adjusts the desired loudness increase

Density: Controls the amount of compression

The Limiter is equipped with SOFT-HARD sound control and the BOOST function

L o u d n e s s M a x i m i z e r 7