Ventilation Requirements
The appliance must have adequate ventilation to ensure correct operation.
Diagram shows the ventilation requirements when installed:
A* Under a worktop, or cupboard.
*The clearance space of 10 cm above the appliance may be reduced to 5 cm providing a clearance space 2.5 cm is left on either side of the appliance.
B When freestanding
Levelling
The appliance must be level. Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance.
If required the washer (2) can be removed.
Door Reversal
If required the door can be reversed, hinged from the left, opening from the right.
To reverse the bottom hinge assembly proceed as follows:
Disconnect the appliance from the electricity supply.
Tilt the appliance backwards, resting the top edge of the appliance on a stool or something similar.
Unscrew the 2 adjustable feet. Unscrew the 2 screws holding the lower door bracket, transfer the lower door hinge pin to the alternative position as shown in the top drawing. Unscrew the single screw at the bottom left hand side and retain . Replace the lower door bracket on the bottom left hand side but do not fully tighten the 2 screws.
15