Use of the refrigerator, A.C. light | Zanussi ZI 9454 X specs

Use of the refrigerator

Control Panel

JON/OFF light

KFridge button ON/OFF

LTemperature setting button (warmest)

MTemperature indicator panel

J.Light ON/OFF

K.Button ON/OFF

ON: Press the button (K). The pilot light (J) switches on.

OFF: Keep the button (K) pressed until the pilot light

(J) and the temperautre indicator switches off.

L - N. Temperature setting buttons

The temperature can be adjusted between +2°C and +8°C.

By pressing the button (L or N), the current temperature setting flashes in the indicator panel. It is possible to modify the setting temperature only with flashed indicator. To set a warmer temperature, press button (L). To set a colder temperature, press button (N). The indicator panel displays the newly selected temperature for a few seconds and then shows again the inside compartment temperature.

The newly selected-temperature must be reached after 24 hours.

Attention!

During the initial stabilising period the temperature displayed can not correspond to the requested temperature. During this time it is possible that the temperature displayed is lower than the actual temperature.

M. Temperature indicator

During normal functioning the indicator shows the temperature inside the fridge.

J K L M N O P Q R

NTemperature setting button (coldest)

OSuper Cooling light

PSuper Cooling button

QD.A.C. light

RD.A.C button

Attention!

Difference between the temperature displayed and temperature setting is normal. Especially when:

-a new setting has recently been selected

-the door has been left open for a long time

-warm food has been placed in the compartment

O. Super Cooling pilot light

P. Super Cooling button

The maximum performance is obtained by setting the Super Cooling function. It’s recommended when loading large quantities of food.

Press the Super Cooling button (P).The relevant pilot light (O) switches on.

The internal temperature goes down to +2°C.

After about 6 hours the Super Cooling function switches off automatically.

Q. D.A.C. light

The D.A.C. light is on by pushing the D.A.C. button.

R. D.A.C. button

Push the D.A.C. button the light will light up.

Operation

Insert the plug in the power socket. Press the button ON/OFF (K). The fridge is switched on.

The fridge is pre-set to run at +5°C. This temperature will be reached in a few hours.