![](/images/new-backgrounds/1089563/8956333x1.webp)
POSITIONING
Height adjustment
The height of the appliance is adjustable from 820 to 870 mm to line up with existing kitchen units.
Before installing the appliance between units, adjust the height of the feet and rear wheels. The wheels are factory set for a height of 820 mm. To align the appliance to a height of 870 mm, raise it by adjusting the feet with a spanner, then remove the wheels and refit them in the lowest position.
Fitting the side panels
¥Fit the brackets onto the panels in the positions shown in the diagram. The dimension of 132 mm is allowed for fitting a 100 mm plinth below the panel. For different plinth sizes, reduce or increase the dimension of 132 mm accordingly.
¥Rest the panels against the appliance.
¥Fit the rear brackets, taking into account the thickness of the panels (maximum width of unit 900 mm).
¥Secure the panels at the front. If using panels less than 20 mm thick, fit spacer plates C, supplied with the appliance, on the hinge side.
| 820 |
| 870 |
820 |
|
870 |
|
REAR | FRONT |
EDGE | EDGE |
RIGHT HAND
SIDE PANEL
15 |
|
|
|
|
|
| 1052 |
820 | INSIDE |
| |
FACE |
|
| |
|
|
| |
15 |
|
| 275 |
280 |
|
|
|
|
|
| 5765 |
| 541 | 20 | 132 |
C |
|
|
|
17