Check the position again by slackening the screws and pins then, once the best position has been obtained, fully tighten all the fixings.
Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket.
Fig. 11
D
D472
Once the door has ben correctly aligned, tighten the holding nuts on the fixing brackets and attach the appliance to the adjacent units and the bottom of the work surface (Fig. 12).
Fig. 12
D517
If the appliance has been fitted into a space 820 mm high and the maximum height of the base plate is 100 mm, fit the front cover plate by pushing the two vertical lugs into the rectangular holes on the bottom side of the ventilation duct until they click. The plate can be adjusted backwards or forwards in the holes (Fig. 13).
Fig. 13
820
870
170
220
600 135 185
D518
If the base plate is between 100 and 135 mm high, cut it as shown in Fig. 15 and mount as described above.
If the base plate is between 135 and 170 mm high, cut it as shown in Fig. 13.
Fig. 14
820 870
100
150 20÷80
min. 50cm2
D546
If the appliance has been fitted into a space 870 mm high and the maximum height of the base plate is 150 mm, fit the front cover plate as described in Fig. 14.
If the base plate is between 150 and 185 mm high, cut it as shown in Fig. 15.
If the base plate is between 185 and 220 mm high, cut it as shown in Fig. 13.
Fig. 15
820
870
100÷135
150÷185
D520
9