Sound Performance Lab 2269 owner manual Rear Panel/Connections, Stereo Inputs, Send Channels 1 to

Rear Panel/Connections

STEREO INPUTS

For connection of the source signal, which will be routed to the eight outputs. Use 1/4” TRS (stereo) plugs for balanced connections and 1/4“ TS (mono) plugs for unbalanced signals. Maximum input level is +19 dBu.

SEND CHANNELS 1 TO 8

These connectors provide the balanced SEND signals from stereo channels 1 to 4 for connection to processor inputs. A send channel will only carry the input signal if the corresponding switch is activated. Standard adapter cables are readily available for these connections (Sub-D > XLR male or female or Sub-D > 1/4“).

The Sub-D connectors are wired according to the Tascam standard:

1 2 3 4 5 6 7 8

GCHGCHGCHGCHGCHGCHGCHGCH

13

25

1

14

G= GROUND, C=COLD (-), H=HOT (+)

The numbers on the cables correspond to the Router send channels as follows:

Cable No. Send Channel Switch Position

1	Send 1 Left
2	Send 1 Right
3	Send 2 Left
4	Send 2 Right
5	Send 3 Left
6	Send 3 Right
7	Send 4 Left
8	Send 4 Right

}

}

}

}

1

2

3

4

Example: if switch 1 is activated, the left side of the stereo signal is present at cable no. 1 and the right side at cable no. 2. Switch 2 routes the stereo signal to cables 3 and 4 and so on.

4