Connection type | Single phase (UK) | ||||||||||||||
Cable connection to the |
| 1 | 2 | 3 | 4 | 5 |
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
terminal block |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
L1 |
|
|
|
| N |
| PE | ||||||||
|
|
|
|
|
| ||||||||||
Mains Voltage |
|
|
|
|
| 240 V | |||||||||
Voltage of heating |
|
|
|
|
| 240 V | |||||||||
elements |
|
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Fuse capacity |
|
|
|
|
| 45 A |
|
|
|
|
|
| |||
Cable section |
|
|
|
| 3x6 mm2 | ||||||||||
NOTE: The earth wire should be about
Brown (L)
Blue (N)
Green and Yellow (PE earth)
After installation and connecting, the cable must be placed so that it cannot at any point reach a temperature of more than 50°C above the ambient temperature.
If the supply cable is damaged, the manufacturer or its service agent or a similarly qualified person must replace it in order to avoid a hazard.
Before connecting check that:
•The fuse and household electrical installation can carry the absorbed current of the appliance (see rating plate);
•The cooker connection outlet or the cooker control switch is easily accessible when the appliance is installed.
How to proceed?
•Unscrew and remove the protective cover at the back of the appliance;
•Connect the power cable to the terminal block of the cooker according to the table no.1;
•Secure by means of cable clamp;
•Make sure that the connection to the
terminal block is matching the supply system, see table no.1;
Refit and screw the protective cover on the back of the appliance.
18 