Tricity Bendix ECD 937 manual Installation, Positioning, Rear spacers

Page 15

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal directions” paragraph.

Positioning

This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each climate classification:

SN +10°C to + 32°C

N+16°C to + 32°C

ST +18°C to + 38°C

T+18°C to + 43°C

It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 16°C. If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.

mm100

A mm10 NP00

B

10 mm

You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4”) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers.

Rear spacers

The plastic bag containing all relevant documentation also contains two spacers to be fitted into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in the Figure. Then turn them through 45° (arrow (A) vertical) until they lock into place.

D200

A

45°

PR60

15

Image 15
Contents Eco Plus Installation Important Safety InformationContents Description of the Appliance Freezer compartment Before usingSetting the temperature OperationFresh food refrigeration Frozen food storageThawing Making ice cubesFreezing Calendar Movable shelvesHealth and Safety Guidelines Maintenance and Cleaning Freezer Something not Working SymptomSolution Low room temperature operationService and Spare Parts Customer Care Department7 0 5 9 2 9 9 2 Exclusions Guarantee ConditionsStandard guarantee conditions European GuaranteeNET Capacity Technical SpecificationsInstallation PositioningRear spacers Green and Yellow Earth Blue- Neutral Brown- Live Electrical connectionsDoor reversal directions Page Page Electrolux plc