Built around a torroidal transformer, the power supply allows for a minimal electromagnetic field with no hum or mechanical noise. The power supply's output side is filtered by an RC circuit to extract noise and hums caused by your power service. 30.000µf capacitors smooth out the positive and negative half waves.
The phantom power is derived from a separate winding in the transformer, a precise current regulator delivers a clean phantom power of 48 volts. High quality 0.1%/ 6,81 kOhm resistors ensure the pristine quality of the phantom power supply.
The supply voltage can be set to 230 V/50 Hz or 115 V/60 Hz. Check your country's power requirements for the appropriate setting. An AC power cord is included to feed the
Chassis ground and AC ground can be physically disconnected by the “Ground Lift” switch (GND LIFT). This helps to eliminate hums.
Frequency Response: | 10 |
|
(50 kHz = |
|
|
Common Mode Rejection: | 1 kHz: | |
(@ |
|
|
THD & N: | Amplification: | A weighted: |
| 20 dB | |
| 40 dB | |
| 60 dB | |
Dynamic Response: | 119 dB |
|
Max. Output Level XLR / Jack: .... | +20 dBu |
|
Output Impedance: | <75 Ohm |
|
Housing: | Standard EIA 19"/3U | |
| ... 482 x 132 x 237 mm | |
Weight: | 7.3 kg |
|
Subject to change without notice.
Power Supply
Specifications
Area 5.1 | 9 |