INTRODUCTION
WARNING: THIS COOKER MUST BE EARTHED
RATING PLATE
Record the model and serial numbers on the back cover from the rating plate. This is situated on the lower front frame of the cooker and can be seen upon opening the fan oven door.
The cooker must be protected by a suitably rated fuse or circuit breaker. The rating of the cooker is given on the rating plate.
INSTALLATION
This cooker complies with Radio Interference requirements of EEC Directive 87/308/EEC.
If your cooker has been damaged in transit, contact your supplier immediately. DO NOT attempt to install it.
Your cooker left the factory fully packaged to protect it from damage. If it is delivered without packaging and damage has occurred the manufacturer cannot accept responsibility. Contact your supplier for advice.
Once the packaging has been removed the cooker should only be moved by hand. DO NOT use a sack barrow or any other aid to lift the cooker as damage may occur.
Connection to the electricity supply must be carried out by a qualified electrician/competent person.
The electrical connection should be made using a double pole isolating switch (cooker socket) with at least 3mm contact separation. The cable must have conductors of sufficiently high
The recommended
The cable should be routed away from potentially hot areas marked by X in the diagram below.
REAR VIEW
To move the cooker, open the fan oven door, and lift the cooker by holding inside the top of the compartment.
This is a type Y cooker which means it is
Ensure that the cooker is standing level.
Side walls which are above hob level should be protected by heat resistant
A nominal air gap of 2mm all around the cooker is required to enable the cooker to be moved into position.
A spacer has been incorporated into the back of the appliance to ensure an air gap of 10mm is maintained at hotplate level. Tiles or other forms of deep wall covering should not obscure this gap.
8