Frigidaire Installation and Preparation Guide for the CFPWD15W Refrigerator
Page 2

Prepare appliance for mounting

Due to higher center of gravity of appliance on ped- estals, some side-to-side rocking is normal during operation. Vibration can be minimized by assuring appliance is installed properly, including being level and solid on all four (4) legs by following these directions.

1.If washer or dryer is new and has not been installed yet, skip to step 4.

2.If dryer is already installed, disconnect dryer from electrical and gas connections and exhaust venting.

3.If washer is already installed, disconnect washer from electrical connection. Turn off hot and cold water supply and disconnect hot and cold water supply hoses from water supply outlets.

Disconnect drain hose from drain pipe. Remove hole plugs from back sheet and reinstall shipping braces and bolts.

4.Protect floor and unit with cardboard or rug and carefully lay the appliance on its side and screw each leg completely into the base.

- EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the appliance.

DO NOT use open dispenser drawer of washer or dispenser cavity as hand-hold location when tipping washer on its side. Serious damage could occur to your washer.

If feet are not completely screwed in, mounting holes in appliance will not align to mounting holes in brackets.

5.If appliance has metal feet with a locking nut, unscrew them, remove the locking nut and reinstall the feet flush to the base.

If locking nuts are not removed on units with metal feet, mounting holes in appliance will not align to mounting holes in brackets.

Prepare pedestal before mounting

1.Locate pedestal

to within a few DO NOT remove foam! inches of its

final location.

Allow for approximately 5 in. (12.5 cm) behind the pedestal for clearance of back of washer or dryer to the wall. Allow additional space if venting dryer upward or downward.

2. Level the pedestal front-to-back and side-to-side by ad- justing each leveling leg. Keep leg exten- sion to a minimum.

adjustable pliers

raise lower

3.Rock the pedestal from corner-to-corner to check for stability. Repeat leveling and rocking until all four (4) feet are sturdy on the floor and pedestal is level.

4.Without turning the rubber foot, lock each pedestal leg in place by tightening its lock nut tight against the pedestal base.

lock nut

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Supports avant Supports arrière 137333700 aFront brackets Rear brackets Soportes delanteros Soportes traserosLock nut Prepare appliance for mountingPrepare pedestal before mounting Attach front mounting brackets Attach rear mounting bracketsWasher on pedestal Installing or re-installing applianceAttach pedestal to appliance Dryer on pedestalPréparez l’appareil pour le montage Préparez le socle avant le montageFixez les supports de montage avant Fixez les supports de montage arrièreLaveuse sur socle Installation ou réinstallation de l’électroménagerFixez le socle à l’électroménager Sécheuse sur soclePinzas ajustables Levantar bajar Prepare el electrodoméstico para apilarloPrepare el pedestal antes de instalarlo Tuerca de BloqueoFije los soportes de instalación delanteros Fije los soportes de instalación traserosLavadora sobre el pedestal Fije el pedestal al electrodomésticoInstalación o reinstalación del electrodoméstico Secadora sobre el pedestalPage No de modèle Model NoDate of Purchase Date d’achat
Top Page Image Contents