Attach pedestal to appliance

1.Turn pedestal on its side to match orientation to appliance.

2.Slide pedestal up to appliance and line up holes in mounting brackets with holes in appliance base.

Special instructions for mounting a dryer with side pane style of 2 indents and 4 inch knockout (see image to right).

•Rear bracket mounts to dryer with wide tabs on bracket into slots on rear of dryer.

SLOT in rear of dryer

Wide hook TAB on rear bracket

4.Using more than one person, carefully return appliance and ped- estal to upright position.

- EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the appliance.

•Engage hook tabs of rear bracket into slots of dryer be- fore aligning front bracket with holes in dryer base.

•Continue with instructions below for attaching front bracket to dryer base.

3.Attach rear and front brackets to appliance base with supplied screws into aligning holes - one in each front bracket and two in each rear bracket.

DO NOT use open dispenser drawer of washer or dispenser cavity as hand-hold location when tipping washer upright. Serious damage could occur to your washer.

5.After retuning appliance upright, loosen each mounting screw going into appliance base. Allow the appliance to settle in the brackets and retighten each mounting screw.

Installing or re-installing appliance

Washer on pedestal:

1.Slide washer/pedestal into place.

2.Check for levelness and rock all four (4) legs again. Repeat until level and solid.

3.Refer to Washer Installation Instructions for complete details on installing water, drain, or electrical.

Dryer on pedestal:

1.Slide dryer/pedestal into place.

2.Check for levelness and rock all four (4) legs again. Repeat until level and solid.

3.Refer to Dryer Installation Instructions for complete details on installing electrical, gas, or exhaust venting.